Kennel Gear Brand, .5" Bar Mount System with 1.25" Thumbscrews

½" Dog Kennel Bar Mount System with 1.25" Thumbscrews — Piranha Lox® Bar Mount for Heavy-Gauge Kennel Bars Up to .875" Thick

The Kennel Gear ½" Bar Mount System with 1.25" Thumbscrews is the Piranha Lox® dog kennel bar mount configured for installations where standard 0.75" thumbscrews do not reach full thread engagement. The longer 1.25" thumbscrews are designed for kennel bars up to .875" thick — heavy-gauge kennel doors, reinforced panel systems, and bar stock that exceeds the capacity of the standard bar mount hardware. The same anodized aluminum mount body, the same 2 5/8" clearance between thumbscrews, and the same full Piranha Lox® locking performance — with the thumbscrew length that thicker bar installations demand. Maximum bar thickness: .875". Confirm bar thickness before ordering.

Key Features

• Piranha Lox® dog kennel bar mount with 1.25" thumbscrews — accepts the insert block built into all compatible Kennel Gear bowls, pails, and other accessories; spring-loaded release tab disengages any insert block in one motion without tools
• 1.25" stainless steel thumbscrews — full thread engagement on kennel bars up to .875" thick where standard 0.75" thumbscrews fall short of a secure hold
• Maximum bar thickness .875" — confirm bar stock measurement against the Kennel Gear System Fit and Compatibility Guide before ordering
• Attaches to vertical or horizontal kennel bars — fits 2.00" x 4.00" welded wire kennel panels, heavy-gauge transport crate doors, and reinforced commercial and veterinary kennel bar systems
• 2 5/8" clearance between thumbscrews — consistent with the standard ½" bar mount system across welded wire and commercial kennel panel configurations
• Anodized aluminum construction — weather and corrosion resistant across indoor and outdoor kennel, boarding, and veterinary environments
• Compatible with all Kennel Gear universal insert mounts — bowls with yokes, pails with insert blocks, IV poles, supply caddies, and any accessory with a compatible insert block

The thumbscrew length is the single specification that separates this dog kennel bar mount from the standard ½" system. When bar stock thickness pushes past what a 0.75" thumbscrew can thread through cleanly, the clamping force drops and the mount can shift under load. The 1.25" thumbscrews thread fully through bars up to .875" thick, maintaining the clamping force needed to hold the Piranha Lox® surface mount securely against the bar through repeated attach-and-release cycles. For installations within the range of standard hardware, the ½" Bar Mount System with 0.75" thumbscrews is the right choice.

For chain link fence installations, see the dedicated Chain Link Fence Mount. Compatible accessories include the 4 Quart Stainless Steel Pail with Insert Block and the full range of Kennel Gear stainless steel bowl and pail systems. For full hardware fit specifications including bar thickness measurements, refer to the Kennel Gear System Fit and Compatibility Guide.

What’s Included

• ½" anodized aluminum dog kennel bar mount with spring-loaded release tab
• Two 1.25" stainless steel thumbscrews

Dimensions

• 3.125" L x 2.00" H x 0.625" D